Electrowave

Operation Manual

1.) Fill unit at east HALF full of liquid before plugging in (3 to 6 inches for EW-500 thru EW~1000 series systems).

2.) Plug into properly grounded outlet.

3.) Turn timer clockwise to 3-5 minute mark and allow ultrasound to ‘degass’ the liquid, prior to cleaning.

4.) Place object to be cleaned into tank. Baskets, beakers and carrier baths may be used.

5.) Fill tank to approximately one-half inch above parts to he cleaned.

6.) Turn tinier clockwise to an ‘ON’ position, cleaning time may be as little as 15-90 seconds, or as long as several minutes, depending on the cleaning solution and the particular contaminate.

7.) It heater option is being used, liquid level must be monitored to prevent liquid from dropping below HALF full,

WARNINGS

• Do NOT plug unit in until tank Is at least HALF full of liquid (3 Inches for EW-500 thru EW-1000 series units).

• High Voltage [100-1000vRMS]. Do NOT operate without proper grounding.

• Do NOT operate the unit dry. Never run heater (optional) if liquid level falls below HALF.

• Keep hands OUT of unit while in operation.

• While filling or emptying the tank, unplug the power cord.

• Keep exterior of unit dry. Do NOT set in liquid.

• Do NOT operate without properly functioning timer.

• Avoid contact with solutions and provide adequate ventilation.

• Do NOT set heavy objects on bottom of tank, use basket.

• Do NOT overfill the tank with parts to be cleaned.

• Use correct voltage only.